Due to ongoing debates about the use and misuse of the “German Support” category to the detriment of users who don’t speak German, the creation of new topics on the category has been closed. Thus, this category is now read-only.

Empfehlung Tür/Fenster Sensoren?

Vielen Dank für die Bilder, das probiere ich gleich mal aus.

Revo hat das Kabel ja an die bestehende Antenne angelötet dessen genaue Länge (ausgerollt) ja nicht bekannt ist. Nach meinem Verständnis sollte die Gesamtlänge ja 17,2 cm sein.

read more

Questions about the release of v0.9

Basic installation on a Raspberry A repeatedly fails

Many Thanks. I probably found my mistake. I’ve always tried to install on an A +. That did not work. Now I’ve installed it on a B +. That went immediately. This µSD is now also running in the A +.

read more
Questions about the Forum and Pimatic.org
Mark all threads as read?

Yes this works, buit only for the thread listed under this unread button.
Not for older Threads.

What i would like to do in fact is to once set all threads to read so that only those threads appear bold where since that point posts where made or new threads.

read more
any trouble with your setup, linux, pi etc.
homeduino doesn't detect first/single transfer


I just recently stumbled over this discussion - I also have problems with signals getting lost - and I tried it out.
At first it was not working at all. Receiving, sending, all functionality was gone. AND: the moment I started receiving also the normal remote would not work for the RF sockets. I though: “What the f**** is going on?” The idea that I just built an RF jamming devices came to my mind… in fact the problem was:
I used D13 on the arduino for my RF sender. And the updated homeduino by is using D13 for an activity LED (hardcoded).
After I fixed this, the device works just fine for my RF switches.
I think I still have a problem with my temperature sensors. Both from Pearl. One is using the weather1 protocol, the other weather18.
No temperature is detected and even when I trigger the sensor to send RF messages there is no input in pimatic. I am using “discover devices” to detect.
Are there any known topics for these kind of devices? Any hints how to debug?
I did some printf debugging. The code never enters the “if(RFControl::hasData())” block in rfcontrol_command.h


P.S. and of course a big thank you to @TheOtherMarcus !

read more

Looks like your connection to pimatic forum was lost, please wait while we try to reconnect.