Hello is Brennenstuhl RCS1000 N comfort supported??
-
Brennenstuhl RCS1000 N comfort
-
Brennenstuhl should be ok. Have a look here
https://github.com/pimatic/rfcontroljs/blob/master/protocols.mdIf not, it can be implemented.
pimatic v0.9 has been released!
Support Pimatic and get some free stickers
Like us on Facebookmake it so !
-
I aded a 433Mhz sender/reciever directly to my raspberrypi
like this link text
here is my config of homeduino
“plugin”: “homeduino”,
“driver”: “gpio”,
“driverOptions”: {},
“receiverPin”: 0,
“transmitterPin”: 1if I try to recieve a message from the sender of brennstuhl rcs 1000N comfort I dind’t see anythin in the log og homeduino like described here
link text -
Did you install wiringpi?
This is necessary. Guess I’ll have to point that out better at the howto
And you should not connect the receiver without voltage divider to 5v ! 5v can damage your gpio portpimatic v0.9 has been released!
Support Pimatic and get some free stickers
Like us on Facebookmake it so !
-
I installed wiringpi and set the reciever to 3,3V
! info [pimatic-homeduino]: Connected to homeduino device.
-
can someone help???
-
@temp
gpio 17 = receiver
gpio 18 = senderthe homeduino setup differs from your above link!
switch the cables and try again.also check the howto : http://forum.pimatic.org/topic/202/4-homeduino-433-mhz-sending-receiving-and-even-more/2
second threat describes how to install homeduino without :To be mentioned : Pin 0 and Pin 1 are the GPIO Pins from wiring Pi
On the Pi it would be Pin 11 for GPIO 0 (wiring Pi) / GPIO 17 (common) and pin 12 for GPIO 1 (wiring Pi) / GPIO 18 (common)
So to keep it simple just connect the data wire from the receiver to pin 11 and the data wire from sender to pin 12 on the pipimatic v0.9 has been released!
Support Pimatic and get some free stickers
Like us on Facebookmake it so !
-
I switched the cables now but didn’t see anything at all
but i know that sender and reciever is working i got an output/input with
! pilight-recieve
is there somethin like pilight-recieve to see the raw data?
I also tested
! sudo pimatic-app/node_modules/pimatic-homeduino/node_modules/homeduino/bin/vhduino
ready
RF recieve 0
ERR argument_error
RF receive 0
ACKBut didn’t get any output