I’m brand new to pimatic, but I handeld ist to install
next step would be to include two ds1820.
wenn I use only the standard image : 2014-12-24-wheezy-raspbian.img
and use the 3step :
sudo modprobe wire
sudo modprobe w1-gpio
sudo modprobe w1-therm
I get the dirs in devices according to the hardwareid - everything is fine.
Wenn I install pimatic into this image and do the same thing,
there will be no dir generated according to the hardwareid.
ofcourse pimatic can’t read the sensors, althought I did the setup in config.json like in
the dirs in /sys/bus/w1/devices are never made.
what could be wrong?