Hello all,
my homeduino device stopped receiving data from the 433mhz receiver. Can someone help?
Thanks
[Solved] Homeduino doesn't receive anymore
Hello all,
my homeduino device stopped receiving data from the 433mhz receiver. Can someone help?
Thanks
@temp Please check the log for error message and post them if any. Is it a new homeduino setup? If not, for how long did it run stable?
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law
@mwittig It run stable for about 6weeks
In pimatic it says:
2015-12-28 16:40:19info [pimatic-homeduino]: Connected to homeduino device.
Receiver PIN is D2/Transmitter PIN D4
is this config corecct?
serialDevice:/dev/serial/by-id/usb-1a86_USB2.0-Serial-if00-port0
baudrate:115200
receiverPin: 0
transmitterPin: 4
Not really still no debug information…Is it possible that the new USB Hub in between is the problem?
reverse your hardware changings and try again …
or attach the arduino directly to the pi and check it out.
pimatic v0.9 has been released!
Support Pimatic and get some free stickers
Like us on Facebook
make it so !
@leader21 it was indeed the USB hub.
Thanks for your help
Seems like homeduino stability issues boil down to powering and/or USB issues most of the time. Do we have a troubleshooting guide for this?
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law
@mwittig said:
Do we have a troubleshooting guide for this?
not yet. we should think of creating a faq / troubleshoot section (maybe in the howto forums)?
we can discuss this at the admin forum or maybe in chat i would suggest.
pimatic v0.9 has been released!
Support Pimatic and get some free stickers
Like us on Facebook
make it so !