Trouble with implementing Intertechno Powerswitches

---

Hello all,

I want to integrate my ITR-1500 and ITLR-3500 PowerRFSwitches. But i have no success…

After starting Pimatic in the “primatic-daemon.log” i can read:
…
…[pimatic] info: New device "RFSwitch
…[pimatic-homeduino] debug: data: “Hardware not supported” unknown message received: Hardware not supportet
…[pimatic-homeduino] debug: data: “garbage collected wiringX library” unknown messages received: garbage collected wiringX library
…[pimatic-homeduino] debug: data: “ready”
…[pimatic-homeduino] info: Connected to homeduino device
…[pimatic-homeduino] debug: data: “ACK”
…[pimatic-homeduino] debug: Receiving on pin 2
…

Additional info: I use a RF Sender/Receiver via GPIO.

Can anybody help?

Thanks

Intertechno usually runs on switch4 protocol. Do you have a device in pimatic? Do you have a remote? What does the debug data from homeduino say if you press the buttons?

If you have no remote, setup a switch device with one of the following codes and turn the device into learning mode. Then switch the device on via pimatic. It should accept the code given by pimatic.

Can you please tell us more about your Rd hardware. Which sender/receiver do you use?

Check our rf hardware tip