Enclosure for Raspberry Pi and arduino

leader21

If you own a printer(or buy one) and not counting the power costs(220W) ,materials, hours and equipment wear I would say the box would cost less then 3 EUR

power doesn’t mind when having photovoltaic on the roof equipment wear is hard to calculate i guess.

Bare in mind when you want to buy one, it’s a lot of work to get it right and after a while you have to fix something and start tuning all over again.

that’s the other side of the coin … but i guess who’s able to set up pimatic is able to set up a 3D printer
is there a significant and lowpriced printer that you can recommend, since i have no clue at all.

incmve

Haven’t Really looked into the lower priced printers. Most of them have the same components.
One of the cheapest is 400 euro? While the duplicator we got here is around 800 euro but that’s a dual printer.

BTW equipment wear isn’t high just every now and then a nozzle that needs to be replaced or something like that.

incmve

Here is cheap one
http://printrbot.com/shop/simple-makers-kit-2/

I also hear good stories about these kind of printers (not sure if this brand is good)
http://www.ebay.com/itm/Folger-Tech-Kossel-2020-RepRap-Full-3D-Printer-Kit-w-Auto-Level-/331397170359