i am using an older itl-500 shutter controller.
I want to steer it with homeduino plugin.
Driver: GPIO
Pin: GPIO 2
Transmitting only

This posts informs about the compatibility between itl 500 and homeduino plugin. Switch 1 Protocol should be used…

But if i want to decode the B (housecode or id) to F000 as this fhem posts says: https://wiki.fhem.de/wiki/Intertechno_Code_Berechnung
the plugin repots : id musst be a number
Which number do i have to use for Housecode B? 01000010 =binary alphabet B

Thanks for help