Release pimatic-raspbee@0.1.6
Hi, thanks. I need your tests to fine tune the plugin.
It would help me if you give in an overview:
Okay thanks.
What it should do:
When pressing ON: Button should go to ON position, dim the slider to 100% and move the blind to fully closed position.
When pressing OFF: Button should go to OFF position, dim the slider to 0% and move the blind to fully open position
When pressing the slider in position 1-100% should make the button go to ON position and move the blind to the desired position. Where 1 is almost fully open and 100 is fully closed.
When sliding the slider to 0 it should fully open the blind and move the button to OFF.
While moving physically it should move the slider in pimatic as feedback to where it actually is in real life.
At least that what the way it was working before and how I build my rules op against.
What it is doing now.
When button press OFF. It opens up the blind fully.
This is correct.
When pressing ON: it goes to the last position it was in when press OFF last time.
When slider is moved to 100 is opening up the blind. This is opposite of what it was doing before.
When slider is moved to 0 it is stopping what it is doing and button is going to OFF position, it should open up the blind.
When slider is moved to 1 it is going to almost fully closed position. This is opposite of what it should do.
I inverted the slider values, if you download the updated fork and replace only the file raspbee.coffee. The be sure; stop pimatic, delete .js, and start pimatic.
Let me know what the results are.
To me it appears that they work correctly. It is only the blinds themselves that have a problem.
Thanks. Will try it
Yes!
Now the slider is working correctly.
Now it is only the button behavior that is different from what it used to be.
(the button in pimatic)
When blind i closed and I press the off button, nothing happens. When pressing ON it goes to the last position when it was before. It should close the blind fully (like when moving the slider to 100)
If it is too difficult to fix then don’t, I can surely live with the current version. Thank you very much for your help! I appreciate it highly.
Now the button in pimatic works correctly. But the live status of the actual position of the blind stopped working. It was working before the change.
Yeah. That’s what I was thinking about. It is not doing that anymore.
Same as before. Still not moving the slider while the blind is moving.
And the slider stays at 0 or 100 until the cover reaches the final position.
I assume when the cover reaches the final position, the slider switches to 100 or 0.
Is this behaviour the same going from 0->100 as going from 100->0?
@simonbove said in Release pimatic-raspbee@0.1.6:
Same as before. Still not moving the slider while the blind is moving.
I changes directly after this post, a bit on this.
You could have downloaded to fast, can you download again (to be sure)
Same behavior in each direction.
When pressing the slider and when using the button.
Pressing on or 100 it will stay at 100, the blind is moving towards 100 and reaches it after 30 seconds. (but if you are not in the room, you don’t know if it actually happened or not)
The same the opposite way. When pressing off or moving slider to 0 it will stay there. The blind will then start moving to open position.
Before, the slider would update every second or so with the position of the slider, while it is moving.
Yes will do
