433 MHz Garage Door Opener on Pimatic ?

---

Hello,

i´m verry new to pimatic .
I woul´d like to know, if i can open my gragage door remotly with pimatic?
Currently i have this sender: http://www.banggood.com/Cloning-Remote-Key-for-Garage-Door-Car-433mhz-Copy-Code-p-923620.html

Can anybody help me please ?

Thank you

Yes it is possible. But let me warn you for the security risk you’re taking. 433 mhz does not work with any authentication. So everybody can access it if they would want to. Personally I would use z-wave or zigbee for it. or just make a wired actuator.

@Frits1980 this is not right in generally.
Most security relevant RF transmissions using the Keyloq Rolling code encryption to secure the transmission.

With Door opener i would not play poker.

You’re right. But I personally don’t call that security.

Maybe you can use an ESP and connect it to Pimatic. So your data is going over your WiFi.

@sweebee
good idea - maybe use the esp with relais. but you’ll have to be sure that there will be never power on both power strips of the shutter motor. it will blow up else …

Thanks for your input:)
I know that there are some security aspects, but in my case that is no problem.
I tried to receive any signals from my current remote control but pimatic don’t show anything

What could be the problem ?

Thank you

I once wired up a garage door opener to the high beam switch on a Yamaha road bike; however, I am a bit more hesitant to go poking around on my new Scrambler without some reassurance from those wiser than I. Has anyone undertaken this effort yet? Curious if you found room near the headlight for the opener or if you tapped into the high beam wiring and ran a wire back under the seat somewhere.
I know, I know…“carry the opener in your pocket” - just looking for some help with a more integrated solution.
Thanks all!