Recording Rolling Code

---

Hallo,
Can I recording with pimatic v0.9 rolling code “011111110000111001011100” from any devices ?
In v0.8 worked perfectly.
Thanks

Hallo,

In v0.8 you could capture the “rolling code” of a switch or a dimmer with “Debug”.
In v0.9 nothing happens under “Debug”.

I use the “DiscoverDevice” to recognize a “rollingCode (switch)”.
I then go on “protocols / rolling1” I get under “options / codeOn / codeOff” in each case a blank line.

Is “protocols / rolling1” not supported in v0.9?

Thanks for an answer.

you still can see the rf codes in the debug messages if your device is compatible with homeduino. the protocol can be used in v0.9 as well.
you need to check the debug codes and create the pimatic switch with rolling code protocol manually as far as i am into the matter. a discovery for rolling code devices does not work since you have several codes to check