Hi,
i am totaly confused…
have done everything in the homeduino howto thread from this forum.
Using Arduino with homeduino sketch, flashed under raspberry.
Plugin working well with Pimatic, sending and receiving works.
But my reception is very very bad. Only receives commands from ELRO AB440R remote if i hold it 10 cm away from the antenna (17,5 cm copper cable).
Very bad reception.
BUT if i put that Arduino on my Macbook and start the Arduino APP and then the Monitor i have a very good reception. 10 Meter or more.
Monitor Command to get RF signals “RF receive 0”.
I can see the little LED on that arduino blink if it gets a command from the remote.
Whats the clue?
Does the Raspberry deliver to less power? (i have a 2A power plug)