Way to check receiver

---

Hello,

I had a pimatic project working 2 years ago, but I stopped it ca 1,5 years ago. Now I wanted to restart this project and made everything new. I reinstalled pimatic and rebuilded my raspberry system.

Everything seems to be working, but I don’t get a debug output with this informations.
Raspberry Pi 1
Arduino nano
Is there a way to check the receiver and the transmitter?

Thanks 👍🏼

@KuebelElch15 sure;

Menu -> Plugins -> homeduino settings -> debug YES

I also had to set “logLevel”: “debug” in my settings… Try through plugin first

Yes my debug mode is true.

@KuebelElch15 …

And still no output?
Did you set both log level and homeduino to debug? Please provide some info when replying.

@KuebelElch15 which device(s) do you want to use with pimatic?
have you seen the howto?
https://forum.pimatic.org/topic/202/4-homeduino-433-mhz-sending-receiving-and-even-more
maybe there is just a mistake in wiring or your device is not "compatible"
do you get an ACK from the homedino device in the debug data? if so, the programming should be ok so far. did you update the homeduino device (your arduino nano) to the latest firmware? which usb controller chip is used on the nano - an FTDI or CH340?
The FTDI sometimes have a problem and need to be resoldered at two pins on the atmega chip.