Hello
I have a problem… sry for my bad englisch.
When i reastart pimatic then switch pimatic the relays on and off like a test.
What can I do that he does not.
lg Spalter
Homeduino Relayboard
Hello
I have a problem… sry for my bad englisch.
When i reastart pimatic then switch pimatic the relays on and off like a test.
What can I do that he does not.
lg Spalter
What do you mean with “Relayboard”? Relays connected to the arduino and using Pin Switch
?
Yes, 8 Relays
Ok, I don´t have this, cause it doesn´t make sense for me. Why don´t you use the GPIO from the Raspberry?(But its maybe the same )
I think it´s cause the Arduino looses the connection to Pimatic(Raspberry) while restarting. And after Pimatic has started it will restore the last State.
I think @michbeck100 can answer this.
i think so too,
but when pimatic starts then switched every relay on and off for one time and then the last state.
@Spalter I can’t really answer this. Sorry. I haven’t used the HomeduinoSwitch yet.
pimatic-hap - pimatic HomeKit bridge
pimatic-echo - Amazon echo integration
pimatic-dash-button - Amazon dash button support
pimatic-alarm - pimatic alarm system
Like my work? Then consider a donation
Follow me: https://twitter.com/michaelkotten
its normal this is the low/high on the gpio on the restart no solution …