433Mhz Switch issue

jodi

Hallo all,

I have an issue with my 433 MHz switch. I found in the debug the protocol I’d 382768 and unit 0. This turn my remote plug on. To swith it off I have to send the protocol ID 382768 with unit 3. I put both protocols to my homaduinoRFswitch. If I use now the switch in Pimatic it first turn on and immediately it switch off again. Is it possible to configure a switch which use one protocol for switching on and a second one for switching off?

Thanks for your help in advance!
Regards jodi

mwittig

@jodi said in 433Mhz Switch issue:

switch in Pimatic it first turn on and immediately it switch off again. Is it possible to configure a switch which use one protocol for switch

It’ll help if you can post a) the debug log messages you get for your switch and b) the device config you have setup for your switch. See also https://forum.pimatic.org/topic/1179/how-to-post-code-snippets-and-alike-on-the-forum on how to post code and configuration snippets.

leader21

and in addition to mwittig, pls post also the brand/type of switch you are using.
would be helpful to know