Trouble with Onewire on homeduino

---

Hello together,

first at all I want to thank all the guys who work on this great software!
I use it now for 9 month and have a lot of fun with Pimatic.
At the moment I want to integrate my DS18B20 sensors (four at my heating system) in Pimatic. They are connected at my Anduino, who control some wireless sockets (work perfect).
But I can`t make the makefile:

I get all the time "make: *** No rule to make target ‘dht_command.h’, needed by ‘build-nano328/homeduino.o’. Schluss."
What can I do?
Any ideas?

This probably means dht_command.h is missing in your libraries

@WW-STY said in Trouble with Onewire on homeduino:

Any ideas?

Looks like a mixture of a master and onewire build. In the onewire branch dht_command.h is named dht.h.
Try make clean all

Thank you for your answers.
I delete the whole homeduino folder and start again… Arduino now is flashed including one wire and the temperature of a single DS18B20 is displayed correctly in Pimatic.
…but with my four sensors in a 1-wire bus it doesn`t work, show all the time from all devices 0 degrees celsius. Isn’t it possible to have more than one device on the Arduino on one pin?

@WW-STY said in Trouble with Onewire on homeduino:

…but with my four sensors in a 1-wire bus it doesn`t work, show all the time from all devices 0 degrees celsius. Isn’t it possible to have more than one device on the Arduino on one pin?

did you define a device for each sensor? stupid question … ok you certainly did
sure you are having the correct adress codes for the sensors? maybe there’s an error.
try to use it with only one sensor and see if it works. then attach the 2nd sensor and so on.