rule does not work.

---

Hello,

I want to make a rule to put down my screen but when i use this:
When $homeduino-analog-sensor.voltage >= 4.65 then it works and when i use:
When $homeduino-analog-sensor.voltage >= 4.65 for 1 second it doesnot work any more.
Any idea???

thanks gerrit.

Maybee it is the “>=” have you test it with “>4.66”?

Ik have also used the “” and it wont work.
Thanks.

@ghv said in rule does not work.:

Ik have also used the “” and it wont work.
Thanks.
Ik have made the rule with the gui mode.

could you post the exact rule?

Hello,

The rule i want to use is:

“rule”: “when $homeduino-analog-sensor.voltage >= 4.65 for 5 minutes and
it is after 9.00 and before 19.00 then press roll3-down”,

When i turn off duration ( for 5 minutes ) then the rule works.

Thanks

Well the rule looks good… Are you sure the value is all the time above 4.65?

Yes,
when i change it to 2 seconds and the value of the $homeduino very low it does not not work.

Try removing the after and before validations, perhaps these are causing the problem : https://forum.pimatic.org/topic/2167/it-is-after-not-the-same-as-in-v0-8

Thanks for the replay,

This is working for me and it waits until its 11.10.
Only when i put for 2 seconds iit wont work any more.

$homeduino-analog-sensor.voltage >= “4.10” and its after 11.10 and its before 19:00 .