[solved] homeduino with Arduino on OrangePi2 >get no recieving infos

---

Hello
I have installed the pimatic 0.9 on an OrangePi 2 with Debian Jessie.
For the 433 MHz sockets I used the Arduino nano with the transmitter and reciever from Amazon.
After installing the OS from scretch the connection to the nano is establisched. ([pimatic-homeduino] info: Connected to homeduino device.)
I use the monitoring function from homeduino and get the PING from pimatic. If I use the remote control I got the recieving infos in the monitor. But I don’t get this infos in pimatic.
The debug settings are on and also the setting “local” : “en”.
I see the message [pimatic-homeduino] debug: data: “PING” in the pimatic-daemon.log file.

The connection with pilight works fine. The switch is in pimatic a “elro_800_switch”. So I use the switch2 and switch3 in pimatic. But it does not work.

What is my fault?
Many thanks for your support.

powerich

Hi! IF this is the same thing I had, try this:

ADD your switch with device autodiscovery, and see IF the switch you added receives. Report back IF it works.

first of all check here for receiver information
https://forum.pimatic.org/topic/487/hardware-tip-433-mhz-receiver-for-pimatic

be arware that the pilight settings may not be the same in pimatic.
next to try is to move your switch closer to the receiver and try again

you can try to enable the pimatic debug settings and try again.

those are my 2 cents for now.

Hello
Yes, I use the cheaper receiver and order now the recomended once. But I don’t think this is the problem. I’m in front on my desk and every hardware is close to me. So the distance is not the problem. If I press the button on the remote control I got this answer in the homeduino “make monitor”:

RF receive 280 996 376 10228 0 0 0 0 01100112011001010101010101120112011201120101011203
RF receive 292 992 392 10196 0 0 0 0 01120110011201010101010101100110011001120112010103
RF receive 284 1000 396 10204 0 0 0 0 01100112011201010101010101100112011001120110010103
PING

So the Anduino nano works, I get also the PING but the connection between the nano and the pimatic is not working propertly.

If I make “Discover new devices” I get nothing by pressing the button on my remote control.

Sorry.
Thanks for your help.
powerich (at the moment without power

Hello
I saw there was an update for the serial port. After installing the update to homeduino 0.9.7 with the UPDATE menu in pimatic it works directly!
Great.

Thanks

powerich (now with power)