Using CUL 433 with a-culfw and Intertechno

---

Hi folks,

currently I am using a self made CUL 433Mhz device having the a-culfw firmware on it. It is communicating with my FHEM installation.
I was looking for FHEM alternatives and found pimatic very interesting. Looking through the list of plugins I saw that CUL/COC is supported. But I am a bit curious.

Question: Is it possible to use pimatic along with my selfmade CUL433 a-culfw and receive signals from a Intertechno wall switch?

I am always a little confused whether a switch is the part receiving commands and switch a power plug or whether a switch is the button on a wall or remote. Therefore I am not sure whether the CUL plugin would work.

Any kind of help is welcome!
Thomas

@smarthomie Hi Thomas, I think the short answer is it is not supported right now.

I started to build my own CUL clone, but I had no time to complete it, yet. May be I can find some time for tinkering after Xmas. My plan is to use the CUL clone with pimatic-coc initially. I am not sure this plugin has been tested with CUL at all.