My Sensors Relays

---

Hi All,

Lot of stuff came this weekend from China. So time to build new things
My Sensors humidity works perfect for weeks now :

I made a standard My sensors Relays actuator with the standard sketch ( http://www.mysensors.org/build/relay ), and It works but after changing the state of the relay it keeps continues filling up my logging with:

info [pimatic-mysensors]: <- MySensorSwitch { sender: 7, sensor: 1, type: 2, value: ‘1’ }

So fast that within seconds Pimatic log has more the 1000 times the same.

Has anybody seen this problem?

Thanks

@bolliebol
check the git issue https://github.com/DheerajKhajuria/pimatic-mysensors/issues/51, especially the post from @icesory https://github.com/Icesory/pimatic-mysensors/commit/2ccf4cfc1e14bd26040652001da43a405ca8c196

That make sense but what is the best way to change de MySensors.coffee file with the new one ?
I can download the file from Github, but when I try to upload with filezilla it doesn’t work. Is there a howto or some information ?

Thanks

Nobody ?

As a newbee I’m a step further.

With 'sudo passwd" root you can make a password for root so you can use FTP or WINSCP to change th e MySensors.coffee file. That was step one.

But was I see happen in the Serial monitor (only after the relais switching in Pimatic) of my ‘Relay actuator’ is a continueus writing in the log with:

Incoming change for sensor:1, New status: 0
read: 0-1-7 s=1,c=1,t=2,pt=0,l=1,sg=0:0
send: 7-7-0-0 s=1,c=1,t=2,pt=0,l=1,sg=0,st=ok:0
Incoming change for sensor:1, New status: 0
read: 0-1-7 s=1,c=1,t=2,pt=0,l=1,sg=0:0
send: 7-7-0-0 s=1,c=1,t=2,pt=0,l=1,sg=0,st=ok:0

etc. etc…

Has anybody an idea ?