And its Done…

I do it so:

I build the “Trust Smart Home Mini-Einbauschalter AWMR-300” in to the Lamp:

than i get a “Trust Smart Home Funk-Wandschalter, AWST-8800” and buy bigger “borders” for my Lightswitch… because the Switch of the Trust wars bigger then mine. Then remove the original Lightswitch (i must do it so only in this Room … long story…) and setup the new border and new cover for my Power socket and turn the switch perm. on with a Luster clamp.

( Normaly to dont have to remove the original switch… just put between the Trust AWST-8800 and the original switch a little spacer and hot glue it )

Last step is to remove the 4 Screw from the backside of the Trust AWST-8800 to get just the Switch without there own boder. Then i attached the Trust AWST-8800 with hot glue on the new boder.

And setup in Pimatic has Switch with Receiving and Sending. Done!

For the Other Rooms, i will just hot glue the bigger borders to the wall and hot glue the other AWST-8800 Switches with a little spacer directly on the old switch… so that old switch will be turned on and nobody can turn it off.

Why now this way?

Because its hard to get the 300-mini mounted like its made for… you need perfect conditions and its not so easy to remove it later

Without a AWST-8800 Switch Pimatic will never gets a feedback if the Light is on or off when you switch it on the mechanical Switch

The new Methode is easy to remove