dear Pimatic-friends,
is it possible zu get ShellSwitch device - values continuous ?
Thanks for regard,
Joseph
ShellSwitch forces bolean value - because its discrete intervall is ignored ?
dear Pimatic-friends,
is it possible zu get ShellSwitch device - values continuous ?
Thanks for regard,
Joseph
@Joseph Hi. You can set the forceExecution
property as part of the device config. The will also trigger the attribute update event continously.
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law
@mwittig thanks for rapid reply,
unfortunately the setting of “forceExecution” was not successful.
The DB-Log shows stil “type = discrete” and “interval = 0” despite of setting intervall = 30000
and there is no refreshing after 30 seconds for the ShellSwitch-Device. Switching on/off is o.k.
All other Sensors (f.e. sysinfo) are working fine.
thanks for the effort
Joseph