I would like to make a rule that does the following:
- If the temp of sensor A is above 50 degreees for 30 seconds the switch SwitchA on
- If the temp of sensor A is below 50 degreees for 30 seconds the switch SwitchA off
That’s easy and done.
Now here comes the challenge. If the rules above have not been triggered for 24 hours, then I would like to have SwitchA being switched on for 10 minutes and then switched off again. This way I can have my heating pump active only when needed, or once every 24 hours for 10 minutes (during days that the pump is not active)
But if the pump has been active for hours today, then the 10 minutes cycle is not needed…
Maybe this can be cut in two questions:
A: How can I have a rule being triggered every x hours? (answer could be, every day at 12:00h), I know…
B: How can I have a rule being triggered every x hours AFTER another rule was triggered…
Thanks (again) for your help!