Dummy-Shutter Device - I dont understand how i can update the States of the up and down Buttons

---

Hello Fellow Users,
i am totally new to automation and Raspberry Pi in general but i found pimatic was really useful for what i wanted because it can easily execute Shell commands.

Now i got myself a WebRelay Module by KMTRONIC. The NIce aspect of this is, that it has its own little webserver where you can switch the relays inside the module by calling a simple web url wich i did using curl.

curl -u admin:admin http://192.168.1.200/FF0200 > /dev/null && sleep 1 && curl -u admin:admin http://192.168.1.200/FF0101 > /dev/null
(The first part turns Relay 2 off just to make sure i dont crash the motor of my shutter
The second part sleeps for one second to give the command time to switch and finally i turn Relay 1 on to drive the shutter upwards - btw this works just as described fine)

Now the Problem is: The Control Dummy shutter has no reset of its state that i can trigger.

I mean when press it it should execute by rule what i wrote above but when i release i would like to have a second rule trigger this, again switching off just relay 1.

Can someone of all you help me getting this sorted out?

what i want is clearly the following:
Button executes Rule while its pressed. If released it excutes something different and if its nothing then it does nothing.

Another question is, wether i can pack the commands into a var wich i can call then like

execute “$vark1up” ?

I would really be happy about anything to assist my idea.

Thanks in advance

7

Maybe someone of you can post a shutter device he or she is using atm and i can use that?

Not sure what you want?
You push the sutter and then in th GUI that shutter button stays blue. You want that to release? You can easily tunn that button if with a rule.

Thanks for your advice. Actually i found out now that it was just my smartphone didnt refresh quick enough.

Thank anyway because this was my first but wont be my last question.