Rules do not work.
Hello,
I have a strange problem.
I have a simple rule : “if pirsensor1 is present then turn Stehlampe on for 5 minutes”
The Log shows that the PIR has recognized presence, the rule is triggered and that "Stehlampe is turned on but nothing happens.
If I trigger the switch for “Stehlampe” now manually off and on again the switch turns on.
Perhaps the repeating of the signal is different when sending manually ?
Tested it with some rules.
Christopher
@crispy
You can try to add a delay…
if pirsensor1 is present then after 2 seconds turn Stehlampe on for 5 minutes
@magic-tune : Tried it, but no change.
Seems like only rules with my PIR-Sensors don´t work. Some other rules only work after some hors after I created them.
Perhaps there is a way to increase the number of repeats ?
Christopher
What kind of PIR are you using? If you’re using a RF PIR perhaps the RF PIR is still sending data when you send the on signal, and the signal isn’t received properly.
