Connecting arduino nano with 433MHz Superheterodyne RF Link kits 3400 ARM MCU Transmitter and Reveiver

---

The question is can i and how do i connect the 433MHz Superheterodyne RF Link kits 3400 ARM MCU Transmitter and Reveiver to a arduino nano WITHOUT a breadboard.
I orderd a breadbourd but that will take weeks to arive and i would like to press on.

greetings Hans

do you have any jumper wires?

if so, just connect these to the necessary pins of the sender/receiver
for ground and 5V wire you could cut of the ends of the jumper wire and make an y-cabel with an luster block.

so your pins of the RF kit will stay clean for your breadboard setup.

regarding the question how to connect the parts to your pi have a look at this tutorial here :
http://forum.pimatic.org/topic/202/4-homeduino-433-mhz-sending-receiving-and-even-more
the example is using the RXB6 receiver and should match your case. Just have a look and if there are any further questions you can use this threat. we will help

I do have jumper wires and found this tutor one hour ago.
The only problem was the dounle ground and 5V wire.
So stupid of me not to think of an y-cabel.

Thanks for this moment of enlightment.

Greetings Hans

you’re welcome
have fun while tinkering around!