Hello everyone,
I have a problem with the RXB6 Receiver. When Pimatic start,i generate a Message that the Pimatic start. This Message, will send over pushover. When i have connect the Datawire to the Raspberry (direct I/O) I became the following Message and he send no Message over pushover.
error [pimatic]: Error on evaluation of rule condition of rule alarm-tur-fenster: socket hang up
00:15:40error [pimatic]: rule alarm-tur-fenster error executing an action: socket hang up
00:15:40error [pimatic]: Error on evaluation of rule condition of rule alarm-pimatic-hat-neugestartet: socket hang up
00:15:40error [pimatic]: rule alarm-pimatic-hat-neugestartet error executing an action: socket hang up
When i disconnect the RXB6, i have no Problems and the Message was send.
Is Pimatic started and runs, i can connect the Datawire to the Raspberry and pushover works normaly.
Does anyone have a solution for that?
UPDATE
When i connect the Arduino Nano and connect the receiver to the Nano, it works normally.
Previously I had had the Reciever XY-MK-5V, it worked with this without problems