[Solved] Problem with receiving over homeduino and Arduino Nano together with Brennenstuhl 1000RC Comfort

---

Hello together,
the old topic isn’t solved but in the meantime I got my adruino nano stick and installed everything as instructed here i also got he message

avrdude Done thank you 

After flashing. When I’m starting

sudo pimatic.js

I got the message the connection works proper

14:06:31.356 [pimatic-homeduino] data: "PING"
14:06:47.852 [pimatic-mobile-frontend] rendering html finished
14:06:48.009 [pimatic] Listening for HTTP-request on port 5001...
14:06:48.165 [pimatic-homeduino] data: "ready"
14:06:48.194 [pimatic-homeduino] Connected to homeduino device.
14:06:48.294 [pimatic-homeduino] data: "ACK"
14:06:48.313 [pimatic-homeduino] Receiving on pin 0

In my opinion everything is okay as expected. But I didn’t receive any command from the control??

What is the error?? Is my receiver wrong?

thanks

@temp said:

What is the error?? Is my receiver wrong?

it’s hard to say without a crystal ball tell us more about your receiver.
there are big differences in receivers. have a look here for our recommendation :
http://forum.pimatic.org/topic/487/hardware-tip-433-mhz-receiver-for-pimatic

Your above log is ok that far.

Ok, I don’t know what exactly I have done wrong before but I solderd everything new and what should i say … Everything is fine now thanks for your patience

The only problem s now that when i switch on in the gui the socket switch off and vice versa ?! Do you have any idea about that?

Guess you are using switch 2 or switch 3 protocol. They are inverted. So just change from 2 to 3 or from 3 to 2

Can I setup my os so that the Arduino Wil be always /dev/ttyUSB0 after restart?

Solved by

What about the inverted switch? Solved ?

Yes -->Closed