WS0002 not always received.

sweebee

I have two ws0002’s but sometimes pimatic can’t receive it for over an half hour. And maybe a hour later it receives it every 30 seconds (the sensors are about 5 meters away). I can’t figure out why.

I thought maybe the receiver is not good, but then i walked about 30 meters away from it and it was no problem.

leader21

@sweebee
formerly i had this issue too, but when i switched to icesory’s RFControl it works fine!
https://github.com/Icesory/RFControl/tree/development
having 4 of them working without issues now.

p4co86

Same issue for me. before i get this issue ive installed just One of These. Now with These i have this Issue. Can someone give a tutorial how to fix that?

Harrdy

my experience with the ws0002 are bad. As soon as i power on the ws0002 all my other arduino generic sensors (5 with a transmit delay of 3minutes) dont work after this (homeduino receiving null). i think the 30sec delay between the transmits is my problem and interrupt and jam the 433mhz band.

i would try to fix this with a LP Filter for 433mhz between antena und rx modul soon

maybe your 2 devices disturb each other.