@bertreb
somehow i have not yet found peace.
and actually i did it as always and as very often as you described. searched for devices, integrated them into pimatic, done.
I have the device simply times xxxx genant . and as you can see on the screenshot, it responds to a button of the FB.
then looked in the variables, the device is there three times
then try again with the rule
when i enter an x i get a very limited selection, unfortunately not the device i am looking for
but if i search for the device in the rule via the id of the variable…
i don’t know this behavior from pimatic, maybe it’s my fault. but at the moment i don’t see him, maybe you can help further.
-
values from ikea remote control transferred to pimatic rule via conbee
"Really, I'm not out to destroy Microsoft. That will just be a completely unintentional side effect." 09-28-2003, LINUS TORVALDS (http://www.nytimes.com)
-
@bertreb said in values from ikea remote control transferred to pimatic rule via conbee:
Is it a ikea remote with the round control with the 4 arrows and a button in the middle?
yes, that is it. the name in deCONZ /phoscon is küche
is that the problem?"Really, I'm not out to destroy Microsoft. That will just be a completely unintentional side effect." 09-28-2003, LINUS TORVALDS (http://www.nytimes.com)
-
@bertreb
I have send a picture from the variable, that’s the I’d.
I have only 3.
I will tomorrow change the name in deCONZ and will then take a new test with the same names."Really, I'm not out to destroy Microsoft. That will just be a completely unintentional side effect." 09-28-2003, LINUS TORVALDS (http://www.nytimes.com)
-
This is how the FB was detected via discover for me as well.
"Really, I'm not out to destroy Microsoft. That will just be a completely unintentional side effect." 09-28-2003, LINUS TORVALDS (http://www.nytimes.com)
-
At first I had in deConz and pimatic also the same name.
But there was the problem as well. Then I changed the name, but only in pimatic."Really, I'm not out to destroy Microsoft. That will just be a completely unintentional side effect." 09-28-2003, LINUS TORVALDS (http://www.nytimes.com)
-
After a trial and error search I found the solution. I have to use the variable to get an output. The quotation marks are also important.
Here is how it works:
when $raspbee_xyz1234567.switch = "1002" then turn Wandlampe on
"Really, I'm not out to destroy Microsoft. That will just be a completely unintentional side effect." 09-28-2003, LINUS TORVALDS (http://www.nytimes.com)