Pimatic does not start anymore

---

Hello, everybody,
i have been running a Pimatic installation for several months which controls a terrarium.
Connected to it are a 433MHz transmitter, several sensors (DHT22, AM 2302) and a 433MHz receiver.
The whole thing on a RPi 3B+. The installation went on for about 2 months when I had to shut down the RPi yesterday and disconnect it from the power for a short time. Since then Raspian still drives up but Pimatic doesn’t load cleanly. The web interface is not accessible at all.

Unfortunately my Linux knowledge is very limited. I worked my way through Google to the deamon log and found the following error.

Does anyone have an idea how I can fix it?
For me this seems like WiringPi would not be loaded correctly or could not be found anymore.

Many thanks
Alex

Doesn’t anyone have an idea?

as it is stated in the error message: gpio29 can’t be accessed. maybe a simple echo "29" > /sys/class/gpio/export can help already.

Remove the plugin rpi-433 plugin and try to reinstall it. Check for error messages during the installation. The plugin is based on the “rpi-433” base package which contains native code and use wiringPi. Beyond this, you can try to get support from the plugin maintainer who does not seem to be active on pimatic forum. Thus you may want to file an issue report at https://github.com/redxeagle/pimatic-rpi433/issues (github registration required).

Thank you both.
I have commented out rpi-433. Afterwards Pimatic started again. When I activated rpi-433 again via Pimatic both went again. Only one rpi-43 device is still causing problems. Somehow one of the 433MHz sockets doesn’t switch off although the configuration hasn’t changed .

Meanwhile I redesigned the device and revised the rules. Unfortunately this didn’t bring any success so far.