My good old Pi2B did’nt want to work anymore (for some reason the USB/LAN chip got extremly hot) so i got Myself a new Pi3B+ on which i installed a fresh raspbian and completely new Pimatic as in the >Manual<. After the installation was finished successfully, i loaded all of the needed plugins. Then the trouble began: As soon as i configure a single device (in this case the >System sensor<), the RAM begins to fill from around 200MB to the full Capacity! Pimatic then reacts extreme slow - if it at least does anything at all. Restarting or booting lets the thing happen again the same way. Could i possibly have forgotten something while installing!?
Screenshot at starting and a few moments later:
And there you could find the Config:
Hoping for help here and leave with best regards