The big ZigBee topic
@justice said in The big ZigBee topic:
hello is it posible to instal the raspbee on the same pi as where pimatic is install because piratic is not starting because the web server from the cons is
Yes, it is possible, but you need to change the port assignment either for the deconz service or for pimatic.
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law
@justice
change the init script:
/etc/systemd/system/deconz.service
you can add start parameters:
ExecStart=/usr/bin/deCONZ -platform minimal --http-port=3535 --upnp=0
as suggested by mwittig change the http port.
i also disabled upnp to prevent conflict with other SSDP service. (upnp=0)
platform minimal is for headless mode.
Thanks it’s working nou and after all logic step to do
@justice said in The big ZigBee topic:
Thanks it’s working nou and after all logic step to do
Great. Just a side note: If you update deconz via the web UI the service script may be overwritten and as a result deconz will be no longer operational. In this case you need to apply the changes to the service script gain and restart deconz
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law
Hi! how high is the cpu load with the raspbee module and some (20?) connected devices?
I have a ConBee module in use.
Cpu load is always < 5% (Pi 3)
Also good to know:
I have five heating termostats (eq-3 MAX!) in use with tons of rules that are triggered every minute.
So one could say, there is no significant cpu load created by the raspbee plugin.
@saxnpaule
5%, great!
which RPi do you have in use?
thx for the fast reply
@saxnpaule said in The big ZigBee topic:
Cpu load is always < 5% (Pi 3)
@00lex said in The big ZigBee topic:
which RPi do you have in use?
I have a Raspberry Pi 2 and around 45 devices connected to deconz. Lights, sensors and switches
CPU is also lower than 5% by default
Hi,
my old raspbee pi was a piB+ with deConz( + Desktop over VNC), a small Pimatic(MQTT) and Lirc in the living room. CPU load 6%. Now work i with my old pi3 with the self sdcard an have 2% CPU load. I have 3 bulbs, 1 dimmer and 1 switch in use.
Pimatic, my hobby.
Hi! Whats the trick with the raspbee and hap plugin? or its just not supported?
its strange cause there is the option to exclude but bulbs don’t show up in HomeKit 
maybe hap can’t handle the presence indicator of the bulb. does anybody know how disable this?
only solution to get bulbs in HomeKit is to use the hue.zll plugin with deconz getaway or use group devices with the respbee plugin
I have one Question regarding the Aqara Gateway & Ikea Tradfri,
in the first post it states “Meshes with Tradfri”.
what does that mean? can I just use Tradfri lights without the IKEA Gateway?
Yes, that is possible
the hap plugin uses a device filter.
i have created a feature request.
Hello,
I experienced that my pimatic with deconz gateway is getting a bit slower and some time some switches won’t react to inputs.
Does someone have a clou why this could happen?
Thank you.
