Commuted RF Switch installation
Hi!
I want to add an RF switch to a room. This room now has 1 lamp lighted on by two commuted switchs. The electrical schema is like this:
Is there any kind of connmuted RF switch witch I could use to light on and off indistinctly from the actual two switchs and the new RF switch?
Thanks!
I don’t know a switch how can this.
In my rooms I have replaced all the commuted switches with RF switches and installed one RF actor to switch the lamp.
pimatic rocks!!!
I have found this kind of switch: http://www.chacon.be/media/sync/54737/From Chacon/54737 User Manual.pdf
It acts as an emitter allowing to keep the original switchs. I think I’ll buy one to make some tests.
I have found a relay module switch activated wirelessly over 433 mhz.
I think that if I replace one wall switch (commuted) by another crossed commuted wall switch and I keep it between the other communted switch and this RF wireless receiver I would keep all the installation commuted, am I right? It should looks like this:
http://postimg.org/image/qa7bt7jur/
The rf relay module in question is this:
http://www.dhgate.com/store/product/new-220v-2-channel-rf-wireless-remote-control/197620081.html
Would it be possible to make this module work with pimatic?
Maybe the “Learning” part of the relay module can cause issues.
I Have found this on ebay: www.ebay.de/itm/Interrupteur-Commutateur-Telecommande-Sans-Fil-1CH-315-433MHz-Recepteur-AC220V-/371123612767
With that chacon DI-O device you have to change all switches. It is not an commuted switch.
