Milight Color set always too blue and full brightness

---

Hello, I have a problem with my Milight Color Devices.
Immediately after every new start from pimatic the Milight Color Devices are put on blue and full brightness.

Well, the new start is not the biggest problem.
I use a Sonoff Basic with HC-SR501 as pir. This should switch the MilightColor Devices at night to nightMode.
Basically this also functions, unfortunately, the light flashes first blue and very brightly and then it begins nightMode.
Really very unpleasantly if one gets all at once very bright, blue light at dark night.
Is there a possibility to change this behaviour of MilightColor?

in my opinion the best solution would be to switch off all milight devices at pimatic restart. @mwittig could you pls have have a look on this when having some spare time?
here`s also a mentioning of the issue
https://forum.pimatic.org/topic/1889/new-plugin-for-milight-pimatic-milight-reloaded/59

and i can confirm a similar behavior on that with my milight devices.
the bridge and another device go to red, another device goes to purple, not fully bright but maybe 50% dimmed.

@leader21
I have a Rule, she says this all Milight switch off, if pimatic starts.
The same Rule sends me notification on the mobile phone: “pimatic works”.
This notification comes a little earlier, before milights switch on.

But as already said, much more badly is short on switch if nightmode should be begun.
Also here I have already tried to switch milight OFF first.