[Solved] Homeduino no debug output

---

Hi there,
since over a year i want to install Pimatic to my home. Mainly to get more comfort into my Intertechno Wall Plugs.
But as a father of a two year old, time is my enemy.

Today i had some time fiddling around with homeduino and pimatic.
First i setup the homeduino, using an Arduino Uno and some of my 433MHz senders and receiver i have lying around. Installed the sketch with the Arduino IDE, fired up the serial Monitor, and see it works.

Okay not optimal without Antenna, but is was able to switch on and of one of my wallplugs.

Next was to install pilight, worked quite well. I directly added the homeduino plugin to my config.json just like the debug settings. Started pimatic, it says that the homeduino device is connected, but on the press of a button on the remote i get no output. I can see the TX LED on the Uno flash, so something is happening.

But not in pimatics output, what can be wrong? The homeduino works on my Mac and on the rPi Terminal.

@darkside40 maybe you can check this post https://github.com/pimatic/pimatic/issues/562#issuecomment-77739301
or the entire post https://github.com/pimatic/pimatic/issues/562

Debug logging was already turned on.
I added the locale setting like it was suggested on github but no change.

Found my failure.

I just put the debug and loglevel settings into the wrong brackets (that one with the http Server settings) in the config.json file.

For what do you use pilight? Homeduino runs without pilight.
And pilight v6 isn’t supported

Was a typo, i only use pimatic.