Homeduino and TFA 30.3125 unable to decode signal

---

Unfortunately I just have bought a new TFA 30.3125 because it is (still) listed as a supported device. And I ran in the same trouble as the rest I this thread …
One question about the “rflink” plugin: Is it possible to use it parallel to the ”homeduino”. I tried it yesterday (using the default settings) and after that my homeduinio did not work anymore until I’ve disabled rflink
Any hint’s?
I’m thinking about returning my TFA back to amazon (and hope it won’t scratch on Jeff Bezos Position as the new richest person on our plant

Cheers - Helene

Yes, homeduino can be used together with rflink. I have it so in operation with me. Important that the controller boards are integrated with the respective ID in the plugin. Whether that works depends on the built-in chip, e.g. The Arduino Nano must have an FTDI chip.

Maybe this helps?
http://www.f6fbb.org/domo/sensors/tx3_th.php
http://www.f6fbb.org/domo/sensors/ws7000_20.php

According to the RFLink Homepage the TFA 30.3125 should be compatible to LaCrosse TX3-TH (or WS7000-20?), which sends using the protocol explained in the link. I try to understand it, but maybe someone is more used to it than I am …