My little hardware setup

---

Hi guys,

here is a little example how my setup is curently.
RF receiver for visual feedback


https://www.youtube.com/watch?v=92gRuwptlOc

The homeduino send/receiver(black box)

The Pi

And the heating relay

Work in progress on the sensor probe box

And the first prototype

did you print the box with an 3D Printer?

I’m interested for maybe some of them!

component list? especially the tiny breadboard.

Looks really good, I might be able to print those for free (or very less)

Breadboard should be this one, nothing special i think, got it already with another arduino prototype shield from china.

http://www.ebay.de/itm/170-400-700-830-Kt-Breadboard-Steckbrett-Experimentierbrett-Steckboard-Auswahl-/290944151883?pt=Elektromechanische_Bauelemente&var=&hash=item43bd9f714b

http://www.ebay.de/itm/Arduino-Prototype-Shield-v-5-mit-Breadboard-fur-Arduino-UNO-R3-Mega-/141552660819?pt=Wissenschaftliche_Geräte&hash=item20f5323153

Thanks!
What sensors would you put in there?
I’d like a box like this with a small LED to show feedback for rules working or commands sent to pimatic.
Something like the “egg”, but with a simpler setup

I got this one, if you can wait, it’s only 1€.
http://www.ebay.de/itm/1Stuck-SYB-170-Mini-Klein-Lotfreie-Brotbord-Steckbrett-Breadboard-gelb-Breadboad-/141551057552?pt=Elektromechanische_Bauelemente&hash=item20f519ba90

My part list:

• 170 pin breadboard connectable EBAY

• 433Mhz Superheterodyne EBAY

• Arduino Nano EBAY

• DHT11 EBAY

• ESP8266 Serial Port WIFI EBAY

• DS18b20 waterproof EBAY

It’s not done yet, I am going to tweak it some more and maybe at a PIR and mounting holes
3D design on Thingiverse

@incmve said:

My part list:

• Arduino Nano EBAY

• ESP8266 Serial Port WIFI EBAY
  :

Did you get the ESP8266 running on Arduino? and what about connection to pimatic?
Was interesting to hear details about how you managed it.

No not yet, I am waiting for my powersupply because the Arduino doesn’t seem to give enough power.

Some new additions to my playground.

My analog KwH meter

atm I am using an “egg” that glows red when the heater is on, blue when off etc.
I am working on a new box that will display temperature and glow the same as the egg, it will also hold temperature/humidity, RF and wifi.
The idea is it will be a blank closed cube and the LED will shine trough the front, I have to test if that works.
If not I will cut a square out so the matrix is open.

This is only on paper atm
I am waiting on my matrix LED