[Solved] DHT22 Senor no longer working on Pin 5 since last update of Pimatic and Plugins
My DHT22 Sensor was working fine for the last months, but after the last update of Pimatic and all Plugins I get the error
"Invalid Pin Number 5" (I think the problem is within dht-sensors plugin 0.9.2)
Any ideas? Anyone else with a DHT Sensor on Pin 5 (WiringPi Numbering like it was with the old DHT-Sensors Plugin)
(Tried also to install BCM2835, but it did not fixed my problem)
All other Sensors on Pin 2,3 and 4 are working without problems with the new dht-sensors plugin.
regards, Marcel
I have a problem with a DHT22 on PIN12, maybe it is an other Problem but I have three DHT22 all three has worked for a few years but now only two working the third on PIN12 gives the same error messages.
@Sonic13 Which hardware platform (Raspberry model) do you use?
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law
I use a PI2.
@mwittig
The patch works!!!
Thanks a lot!
patch works also for me. thank you
