pimatic-coc w/CUL not showing remote presses

---

I have a CUL module up and running with some FS20 switches I have. I can control these switches no issue in pimatic and it works great.
But unlike with my RFLink when I press the original remote pimatic doesn’t register the press and toggle the switch in its database.

These are Conrad FS20 switches. The remote shows a command FE3D30212 (it’s a one button remote so it just toggles) when reading from CUL over serial

i had this problem to at my first homeduino-setup.

The problem were the cheap receiver-modul.

I have just bought a bedder one and then pimatic recognized all of my rf-devices.

Have a look here where @leader21 is presenting some modules

[Hardware Tip] 433 MHz Receiver for Pimatic

Mit freundlichen Grüßen
Chris

@chris thx for mentioning.
well, the FS20 is 868 MHz, therefore the RF modules in the given link do not help here.
the cul is a special transceiver for eg. 868 MHz transmission for Homematic, FS20 etc…
maybe the toggle function needs to be implemented?
is it possible to autodiscover the remote?

why the switch does not toggle i cannot tell you, sorry! maybe another @developer has any clue?

@leader21 said in pimatic-coc w/CUL not showing remote presses:

@chris thx for mentioning.
well, the FS20 is 868 MHz, therefore the RF modules in the given link do not help here.
the cul is a special transceiver for eg. 868 MHz transmission for Homematic, FS20 etc…
maybe the toggle function needs to be implemented?
is it possible to autodiscover the remote?

why the switch does not toggle i cannot tell you, sorry! maybe another @developer has any clue?

Yeah; thats a different system entirely.
I’ve been poking at the code a bit and there are some odd things in it. Debug logs aren’t acutually written and I think it’s not setting the CUL into recieve mode. I have it now logging the recieved strings into the log and such but still working on getting them handled

Oh ok sry i didn’t look at the devices @Aaron-Katz mentioned.

@leader21
Just wanted ti say you were right! It doesn’t handle the toggle command so it just ignored it when it gets it!
Working on a workaround for it now