I started again playing with a relay node. At the moment it’s only on desk, but in future I want to integrate into my wall switches. But I wondered how pimatic is handling the ACK or better the case of getting no ACK when it is requested.
As far as I understood in the mysensors.coffee on line 1470 and following the MySensorsSwitch is requesting an ACK.
In my setup I have a few lost messages due to problems with signing. So when the message is dropped during transport pimatic gui shouldn’t switch it’s state, right? But it does in my case. The message is not received properly (and relay is not switched) but pimatic shows it’s done. To resend the on command I have to first switch off in pimatic. Is that the wanted behaviour?