external selfmade pimatic+max! thermostat control with esp8266

xCite86

i found a nice solution via mqtt, sending from ESPEasy to to Broker and getting the variables into pimatic works well, sending from pimatic to broker too, but ESPEasy wouldn’t recognize the payload data and did not change the variables.

after rebooting ESPEasy should get variables from Broker with activated “mqtt retain msg” :

ip:192.168.0.254,mask:255.255.255.0,gw:192.168.0.1
WIFI : Connected!
INIT : I2C
INIT : SPI not enabled
MQTT : Connected to broker
Subscribed to: /Thermostat/#
INIT : Boot OK
INIT : Normal boot
EVENT: System#Boot
MQTT : Topic: /Thermostat/temp1/thermostattemp1
MQTT : Payload: 6.0
MQTT : Topic: /Thermostat/temp1/%valname%
MQTT : Payload: {"idx":33,"nvalue":0,"svalue":"8.00"}
MQTT : Topic: /Thermostat/variables/temp1
MQTT : Payload: 5.5
pm open,type:2 0

but the variable (5.5, /Thermostat/variables/temp1) won’t change after start

Bild Text

if i change the setpoint of my thermostat in pimatic, the esp gets some payload data, but the variable stays to 0

MQTT : Topic: /Thermostat/variables/temp1
MQTT : Payload: 15

Bild Text

pressing the Temp+ button a few times ESPEasy sends the value to the Broker

...
SW   : State 1
EVENT: uptemp1#Switch=1.00
ACT  : TaskValueSet 5,1,5.0+0.5
ACT  : Publish /Thermostat/variables/temp1,5.5
MQTT : Topic: /Thermostat/variables/temp1
MQTT : Payload: 5.5
MQTT : Topic: /Thermostat/variables/temp1
MQTT : Payload: 5.5

maybe anyone knows whats wrong in my settings…

rules@ESPEasy

On uptemp1#Switch do  
  if [uptemp1#Switch]=1
   TaskValueSet 5,1,[variables#temp1]+0.5
   Publish /Thermostat/variables/temp1,[variables#temp1]
endon

On downtemp1#Switch do  
  if [downtemp1#Switch]=1
   TaskValueSet 5,1,[variables#temp1]-0.5
   Publish /Thermostat/variables/temp1,[variables#temp1]
endon

Bild Text

… and 2 pimatic rules:

when $WorkroomHeatingThermostat.temperatureSetpoint changes then after 2 seconds publish mqtt message "$WorkroomHeatingThermostat.temperatureSetpoint" on topic "/Thermostat/variables/temp1"

when $mqtt-thermostat.Workroom changes then after 2 seconds set temp of Workroom Heating to $mqtt-thermostat.Workroom

Maybe mqtt-pro @wutu ?
or @Developer

edit: okay, i think i got it work with MQTT Import Plugin from the Playground
http://www.esp8266.nu/forum/viewtopic.php?f=4&t=1148&hilit=payload+mqtt