I’m interested in the input, 3-pin connector.
-
Know the type of connector?
Pimatic = Smart Home
-
http://www.ckmmold.com.tw/product_view.php?cid=2397&sid=2450
But no idea where you could order it
this is the manufacturer. -
Thx
You can buy here: http://www.aliexpress.com/item/Analog-sensor-connection-cable-15cm-for-arduino-10pcs-lot/32292166342.html
But the exact name of the connector do not know anyways
Pimatic = Smart Home
-
The product code of the terminal is C-Grid-03-70553. I think it is C-Grid Molex connector with three pins. This should be the right connector: http://www.digikey.com/product-detail/en/molex-llc/0050579403/WM2901-ND/115034. This is the terminal: http://www.digikey.com/product-search/en?mpart=0705530002&vendor=900. Found this via the schematic included in the following blog post:
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law
-
@mwittig Thank you very much. I was on that page, but I missed it.
Pimatic = Smart Home
-
@wutu Welcome. If you don’t need the latch to keep the connector tight in the terminal, possibly, a classic 3-pin jumper will also fit. Something like this http://www.amazon.de/Kostenlose-Lieferung-Jumper-Kabel-DuPont-Arduino/dp/B00QPBI6MW. May be you have some spare to give it a try.
However, it is safer to use a proper connector witrh a latcher (or perhaps to solder the wires to the PCB depending on the use case)
"It always takes longer than you expect, even when you take into account Hofstadter's Law.", Hofstadter's Law
-
@mwittig An excellent idea. I miss latcher quiet. This is not critical installations, only aquarium.
http://www.aliexpress.com/item/5-Pcs-High-Quality-F-F-3-Pin-20cm-2-54mm-Female-to-Female-Jumper-Wire/32510468036.htmlPimatic = Smart Home
