I used a standard EspiMatic 0.1.26 build on a nodemcu 0.9 with a ds18b20 connected.
I now made 2 changes:
- My Chromebook was running Lubuntu 15.10 natively (with custom firmware) and now it runs since a few days GalliumOS 1.0 natively, which means that I reinstalled arduino 1.6.5 and the esp boardmanager 2.0.
- The second change is that I added the code for a static ip-address to the Espimatic code.
I “burned” the new sketch to the exact same nodemcu which was already configured for this. So in fact only an .ino “update” on an already completely configured 0.1.26 espimatic.
So I rebooted the nodemcu and to my big surprise I now get the temperature in Fahrenheit instead of Celcius.
I already googled around but I can’t find a solution.