Hi,
is it possible to restart the homeduino board with a command? Sometimes it hangs up when i make some changes on pimatic, so i have to plug it out and back in to get it reconnected. It would be nice to send a command to reboot it.
daice
restart homeduino via command
Hi,
is it possible to restart the homeduino board with a command? Sometimes it hangs up when i make some changes on pimatic, so i have to plug it out and back in to get it reconnected. It would be nice to send a command to reboot it.
daice
you could modify your usbcable and switch +5V via Relais wich was connected on your gpio pin of raspberry…
sorry, this was maybe a dirty solution, but it solve your problem
edit: maybe you found here anything to unload your driver
If you are running on a RaspberryPi B+ or newer you can actually switch the power of the usb ports
https://www.raspberrypi.org/forums/viewtopic.php?f=29&t=93463
You could do this with an shellscript
I get no error messages from pimatic or the homeduino plugin when pimatic boots up. But if i try to send some RF Signals i get a timeout, no error. So i shutdown pimatic, disconnect the arduino, plug it back in, start pimatic again and everything works fine…
Hello,
maybe your suggestions could be solve with this gimmick.
https://forum.pimatic.org/topic/1311/homeduino-device-not-initialized-on-raspberry-boot/2
For me it work’s fine, and you don’t need a command to restart…
Mit freundlichen Grüßen
Chris