homeduino is up to date. Yesterday I set pimatic up from scratch cause I migrated from Pi1 to Pi2.
After this, it did not work. But I found a solution. (the solution has noting to do with upgrading from Pi1 to Pi2)
My brennenstuhl sockets should be configured as switch3, described here: https://github.com/pimatic/rfcontroljs/blob/master/protocols.md
So I configured them as switch3 and “houseCode …” during the first test after the first config (this was days ago on Pi1), they worked fine and after this, I never get them to work again. With rules enabled, I get these timeout messages.
After disabling the rules, the timeout was gone but they still won’t switch.
So I thought, ok lets try “switch4” with *“Id and code” and after this they are switching and rules are working fine.
Is this a bug in homeduino or just a error in the protocols document?