@noxx Looks like they did not work again templates.
-
ESPEasy with Pimatic over MQTT
Pimatic = Smart Home
-
it works now
problem was
wrong IP in my Router Firewall
and wrong hostname in pimatic“mqtturl”: “mqtt://192.168.1.81"
was wrong
"mqtturl”: “mqtt://localhost”,
was righti try to check the connection on my pi with
mosquitto_sub -v -t \#
and get
/esp01/system/uptime 1500.00
/esp01/system/freeram 25464.00 -
@noxx So mainly that errors had been found.
Pimatic = Smart Home
-
is this right for a SR04 sensor?
{ "name": "ESPeasy Distance", "id": "espeasy01-sr04", "class": "MqttSensor", "topic": "/espeasy01/SR04/Distance", "attributes": [] }
-
@noxx Maybe I would add unit, but otherwise correctly.
Pimatic = Smart Home
-
Hey, just installed mqtt and flashed espeasy to my nodemcu v3 with a relay connected.
I’ve managed to receive state from the broker. But I’m not able to change the state of my relay via pimatic. I’ve tried the following as topic:/esp01/gpio/10/set
and/esp01/relay01/state
.any ideas?
-
@Partovic said in ESPEasy with Pimatic over MQTT:
I’ve managed to receive state from the broker. But I’m not able to change the state of my relay via pimatic. I’ve tried the following as topic: /esp01/gpio/10/setand /esp01/relay01/state.
Hi, use only
/esp01/gpio/10
.Pimatic = Smart Home
-
Hey, unfortunately this doesnt work for me. Did you configure any Special in your espeasy device?
-
The Broker Output says it publishes the STATE to the esp. But the esp doesnt seem to react to that command
-
Ok. Forget that. Seems I’ve accidentally deleted thr GPIO Setting in my device. Now it works! Thanks!