ESPEasy with Pimatic over MQTT

---

it works now

problem was

wrong IP in my Router Firewall
and wrong hostname in pimatic

“mqtturl”: “mqtt://192.168.1.81"
was wrong
"mqtturl”: “mqtt://localhost”,
was right

i try to check the connection on my pi with

mosquitto_sub -v -t \#

and get
/esp01/system/uptime 1500.00
/esp01/system/freeram 25464.00

@noxx So mainly that errors had been found.

is this right for a SR04 sensor?

    {
      "name": "ESPeasy Distance",
      "id": "espeasy01-sr04",
      "class": "MqttSensor",
      "topic": "/espeasy01/SR04/Distance",
      "attributes": []
    }

@noxx Maybe I would add unit, but otherwise correctly.

Hey, just installed mqtt and flashed espeasy to my nodemcu v3 with a relay connected.
I’ve managed to receive state from the broker. But I’m not able to change the state of my relay via pimatic. I’ve tried the following as topic: /esp01/gpio/10/setand /esp01/relay01/state.

any ideas?

@Partovic said in ESPEasy with Pimatic over MQTT:

I’ve managed to receive state from the broker. But I’m not able to change the state of my relay via pimatic. I’ve tried the following as topic: /esp01/gpio/10/setand /esp01/relay01/state.

Hi, use only /esp01/gpio/10.

Hey, unfortunately this doesnt work for me. Did you configure any Special in your espeasy device?

The Broker Output says it publishes the STATE to the esp. But the esp doesnt seem to react to that command

Ok. Forget that. Seems I’ve accidentally deleted thr GPIO Setting in my device. Now it works! Thanks!