Problem with homeduino (looks like transmitting all the time)

---

After a while I have problems with homeduino.
The transmitter doesn’t work anymore an I can’t switch on swtichen from pimatic.

I also discoverred that turning on or off of devices (like klik-aan) is not possible with the original remote control.
After pulling out the usb cable from the Rapsberry the original remote works again. It like the transmitter on the homeduino is transmitting all the time.

I installed all the update by the frontend. After restarting the raspberry every thing work nicely for a while…

My question is what can be the problem?

Thanks in advance…

@lschip did you use an Arduino? How old is the Transmitter?

Yes, I used a arduino and the transmitter is rather fresh (about 2 months)

I had had that several time over the past weeks.
homeduino reveiver seems to work fine but the sender stops, when I switch something I get a timeout in pimatic.
After restarting the Pi it works again.
No hardware has changed, I am going to replace my sender to see if that helps.

But my problem is that then also my original remote control doesn’t work anymore (only from a very very short range).
Its like the signal of the original remote is pushed away.
After disconnecting the ubs cable of the arduino with transmitter from the rapsberry the original remote works again.

Have you change the rf repeats in your config? Eventually exist there an bug and the arduino dont stop repeating the command.

@lschip said:

But my problem is that then also my original remote control doesn’t work anymore (only from a very very short range).
Its like the signal of the original remote is pushed away.
After disconnecting the ubs cable of the arduino with transmitter from the rapsberry the original remote works again.

I have not tested my remote, going to try that when the problem starts again.

@Icesory
No, I did not change the rf repeats.
Strange is that it works nice now for several days.