I’ve just received by new receiver today and it’s far better than the one from Amazon which I’ve used so far. I get a much better reception and even receive data from some other devices I’ve never seen before.
I’ve also tested the receiver with my contact sensor and I can receive the signal without any problems, even though there are two walls between the receiver and the sensor. One big problem, however, remains unsolved: I can’t receive any data from my WS0002 with the 3400RF.
Here’s an example of the data I receive with my old sensor when I press the TX-button on the WS0002:
When I attach the new receiver and repeat the exact same procedure, nothing happens. Nothing shows up in the debug-log. No data from the WS0002 and not even some random, undeciphered RF-data. Just nothing. Again, any other sensors work fine without the new receiver.
Any ideas what could be wrong here?