Hello,
Since then I’ve logged the following device I get the debug permanently Ack messages.
{
"id": "homeduino-contact-sensor",
"name": "Contact Pumpe",
"class": "HomeduinoContactSensor",
"pin": 14,
"interval": 1000,
"inverted": false
},
debug [pimatic-homeduino]: data: "ACK 0"
10:25:22debug [pimatic-homeduino]: data: "ACK 0"
10:25:21debug [pimatic-homeduino]: data: "ACK 0"
10:25:20debug [pimatic-homeduino]: data: "ACK 0"
10:25:19debug [pimatic-homeduino]: data: "ACK 0"
10:25:18debug [pimatic-homeduino]: data: "ACK 0"
10:25:17debug [pimatic-homeduino]: data: "ACK 0"
10:25:16debug [pimatic-homeduino]: data: "ACK 0"
10:25:15debug [pimatic-homeduino]: data: "ACK 0"
10:25:14debug [pimatic-homeduino]: data: "ACK 0"
10:25:13debug [pimatic-homeduino]: data: "ACK 0"
10:25:12debug [pimatic-homeduino]: data: "ACK 0"
10:25:11debug [pimatic-homeduino]: data: "ACK 0"
Is there any way this message turn off without deleting the device from the config?
It is very difficult to read a debug a device because the ACK message is permanent.